Flashing in Camillus
Roof flashing repair in Camillus: a leak at the chimney or wall line
Roof flashing repair in Camillus begins at the joint, not in the middle of the shingles. If water shows up beside a chimney, a vent pipe or an addition wall, tell us which and book a visit.
Asking where the water gets in commits you to nothing.
What we do
We help you find where the water really gets in and book a diagnostic visit with an independent roofer, who puts the fix in a written proposal.
Our word before the ladder goes up
- You owe nothing for asking, and you can walk away.
- The visit looks for the way in before any roof talk.
- You see the repair proposal in writing before work starts.
- The $100 credit follows the rules on our Terms page.
The roofer you hire answers for their own work and contract.
Signed Roofing Pros Syracuse, (315) 640-3590
What this word covers
Questions
Questions about roof flashing repair, for Camillus
Can a bead of sealant fix a leaking chimney joint?
Sealant alone is a patch on a joint that may be built wrong. Ask whether the roofer plans to add or rework flashing, or only to caulk. The written proposal should say which.
How do I know which joint is leaking?
Timing and position help. A stain beside the chimney after rain points there first. A stain along an addition wall points at the wall joint. The roofer confirms it at the visit.
My siding looks fine. Could water still be getting in?
Yes. Newer siding can hide wall flashing damage for years. A clean wall does not clear the joint behind it.
Will the roofer need to open up my siding?
Sometimes. Reaching a wall joint can mean lifting a course of siding. Ask whether the proposal includes that, and whether putting the siding back is in the price.
Roof flashing repair where a Camillus addition meets the old wall
Housing built from 1950 to 1979 commonly has a room or garage added later. That is a proxy, so ask what was added. Wherever a lower roof meets a taller wall, the code calls for flashing that is continuous or stepped, at least four inches high and four wide, so it carries water back onto the shingles or to the gutter.
That is the structure of the joint. It is not a statement about your wall. Ask the roofer to show you the flashing, whether it steps with the shingles, and where it ends at the gutter.
Siding can hide a failed joint for years. Newer siding such as vinyl, fiber cement or brick veneer can cover water damage that peeling paint on old wood would have shown. So a dry-looking wall does not clear the joint behind it. If your stain keeps coming back, ask for the siding to be checked at that joint.
Signs
Marks that point to roof flashing repair in Camillus
Stain beside the chimney
A ring on the ceiling or wall nearest the chimney points at the chimney joint. Note which side of the chimney.
Stain along a wall that rises above a lower roof
That is the spot where an addition or porch meets the house. Tell the roofer which wall.
A drip at a vent pipe or a bath fan hood
Both cut through the roof. Ask the roofer to look at each one before anything else.
Damp siding below the roof edge
Water running behind siding can show on a wall, not a ceiling. Note the wall and the room beside it.
Chimneys and vent pipes on Camillus houses: who sets the rule?
For a vent pipe, soil stack or chimney, the state code gives no dimensions. It says the flashing has to follow the shingle maker's instructions. So the useful question is simple: which instructions did the roofer follow, and can you see them?
A wide chimney has a second rule. A chimney wider than 30 inches, measured across the slope, calls for a cricket or saddle on its uphill side, so water splits and runs around it. Do not climb up to measure it. Ask the roofer to measure the chimney across the slope and say whether a cricket is there.
If the chimney is fine and the stain appears after a cold night, look to the article on where roofs actually leak and our Camillus diagnosis page.
The kick-out where a Camillus roof edge ends against a wall
At the lower end of a roof-to-wall joint sits a small bent piece called a kick-out. It turns the water into the gutter. If it is missing, the water can run down behind the siding instead.
You can check this from the ground. Look at the lowest corner where the roof edge meets the wall. A gutter should be there, and the metal should curve out toward it. Write down what you see and tell the roofer. It is a small part, and it can be missing from the first proposal if nobody asks.
The same goes for price. What moves it is how many joints are involved, whether siding has to come off to reach one, and what the roofer finds underneath. Ask for each joint to be named in your proposal, so you can tie each charge to a joint.
Other ways in
When roof flashing repair is not where Camillus should begin
Roof Leak Diagnosis
Trace the stain to its source first.
Low-Slope Roofing
Ask for the pitch before anyone patches again.
Gutters and Drainage
Follow the water from edge to ground.
Attic Ventilation
Seal the ceiling before adding any vents.
Nearby
More roof flashing repair pages around Camillus
Tell us which joint is dripping and book the visit.